You can see in the third image below where to change the thickness. This is the best quality for cutting out images. You will also want the thickness of the vector lines that you want cut set at 0.001'. Alternatively for vector cutting, you just need an outline of where to cut. You have to make sure the color mapping box has been checked so it knows to refer to the different settings for different colors.įor engraving, fill in the entire area you want engraved. Shown below is a color scheme with red as raster and black as the vector color. From here you can change whether a color is for raster or vector cutting. You can make sure the page size is correct for your paper. This page will start you on a tab called General. Once on this page, select setup and then select preferences. This is when you have to decide which color represents a raster (engrave) and what color is for a vector (full cut). Once you have your image on the screen you will want to decide if you want to engrave this image or cut it out completely .